Connection of network cable

If you are experiencing interference due to the presence of several Wi-Fi networks or other signals that affect the proper functioning of Wi-Fi, you can avoid using the supplied access point and connect the NIDO Industrial/NIDO ONE V2 directly to the RJ45 network cable. Here is how to proceed.

  • 1
    Remove the device’s steel panel by unscrewing the fixing screws.
  • 2

    Remove the black cap located on the steel plate and use the resulting opening to pass the RJ45 network cable through.

  • 3

    Inside the device, you will find a blue electronic board equipped with one or two RJ452 network ports.

  • 4

    Connect the network cable to the available port on the blue circuit board.

  • 5
    Close the device’s steel panel and tighten the fixing screws.

After restarting the device, the lights on the side panel should remain lit as follows: red light on the left and blue light on the right.

If the blue light is flashing, it indicates no internet connection. In this case, it is necessary to check the router for firewall blockages.