Configuring with sim card

To configure the NIDO Industrial/NIDO ONE V2 with a SIM card, you need to purchase the D-LINK DWR-932 4G modem separately. Pairing procedure with NIDO Industrial/NIDO ONE V2: Before you start, make sure to turn off the access point. Then place the NIDO Industrial/NIDO ONE V2 and the DWR-932 no more than 1 meter apart.

  • 1
    Turn on the NIDO Industrial/NIDO ONE V2.
  • 2
    Wait approximately one minute for the NIDO Industrial/NIDO ONE V2 to start up.
  • 3
    Turn on the DWR-932.
  • 4
    Press the WPS button on the NIDO Industrial/NIDO ONE V2 for 12-15 seconds, or until the blue light on the left side starts flashing.
  • 5
    Press the “WPS” button on the DWR-932.
  • 6
    Wait approximately 30 seconds for the pairing to complete. This is indicated by both blue lights on the side panel of the NIDO Industrial/NIDO ONE V2 flashing intermittently.
  • 7
    If the procedure is unsuccessful, turn both the NIDO Industrial/NIDO ONE V2 and DWR-932 off and on again, and repeat the procedure.

Follow these steps carefully to ensure proper configuration of your NIDO Industrial/NIDO ONE V2 with the SIM card.